New Software for the Aicon 3D Systems TubeInspect S

Our Aicon 3D measurement system has recently had the new BendingStudio software installed.

This upgrade means our measurement system is now completely up-to-date!

BendingStudio now also allows us to measure bent tubes with deformed ends. The data collated is then sent directly from the measurement system to the bending machine, and any deformities can then be corrected immediately.

This saves us considerable set-up time during the proto-phase.

The new software also provides us with many possibilities to carry out repeated measurements and to analyse the data collected.

Thanks to the new software, we are now much better able to demonstrate the stability of our processes using SPC.

Leave a Reply

Your email address will not be published. Required fields are marked *